Filter
Top Products
With an automatic transmission, the vehicle must be in
PARK (P) to recall the stored driving positions.
With a manual transmission and the engine is running,
the parking brake must be set to recall the memory
seat driving positions. The stored driving positions can
be recalled without setting the parking brake if the
vehicle is off.
Press one of the numbered memory buttons to recall
the stored setting. Each time a memory button is
pressed, a single beep will sound.
Three chimes sound and the setting is not recalled if
you press button 1 or 2 when the vehicle is not in
PARK (P) on an automatic transmission or the parking
brake is not set on a manual transmission.
To recall the stored driving positions when unlocking the
vehicle with the transmitter or after the key is placed
in the ignition, see DIC Vehicle Customization on
page 3-68.
To stop recall movement of the memory feature at any
time, press one of the power seat or mirror controls.
Two personalized exit positions can also be
programmed. Use the following steps to program exit
positions:
1. Press memory seat button 1, or the unlock button
on the transmitter, to recall the driving position.
2. Adjust the driver’s seat to the desired exit position.
3. Press and hold the exit button located above
buttons 1 and 2 on the driver’s door armrest
for at least three seconds.
Two beeps sound to confirm that the exit position
has been saved.
4. Repeat the procedure for a second driver using
memory seat button 2 or the transmitter.
To recall the stored exit positions, press and release the
exit button. One beep sounds, and the seat moves to
the stored exit position for that driver. If an exit position
has not been stored for this driver, the seat moves
all the way back. The position of the outside mirrors
does not change for the exit position.
If your vehicle has an automatic transmission, the
vehicle must be in PARK (P) to recall the exit positions.
If your vehicle has a manual transmission and the
engine is running, the parking brake must be set to recall
the stored exit positions.
Three chimes sound and the exit setting is not recalled
if the exit button is pressed when the vehicle is not
in PARK (P) on an automatic transmission or the parking
brake is not set on a manual transmission.
To recall your stored exit positions when unlocking the
vehicle with the transmitter, or when the ignition is
turned off and the driver’s door is opened, see DIC
Vehicle Customization on page 3-68.
1-7