Bulldog Security 500 Automobile Alarm User Manual


 
. .
9
OPERATION
K. ACTIVE DISARMING  UNLOCK & DISARM:
1. Press the
button on the transmitter.
2. The siren will chirp (2) times and parking lights will
flash (2) times and then remain ON for 30 seconds
indicating that the security system is now disarmed. The
vehicles doors will unlock and dome light will turn ON
for 30 seconds upon disarming when interfaced with the
security system.
System
Disarm
TWO STEPS DOOR UNLOCK: This feature will independently unlock the
drivers door only when disarming the security system. Pressing the
button a second time within 3 seconds will unlock the remaining doors.
AUTOMATIC RE-ARM: If this feature is selected, the security system will
automatically re-arm itself in 60 seconds after disarming with the remote
transmitter. Automatic rearm will cancel if any door is opened before the
60 second timer has elapsed.
L. DISARMING WITHOUT A TRANSMITTER
OVERRIDES THE ALARM WITHOUT PASSWORD PIN CODE:
The override function may be used if the remote transmitter is lost or
inoperative.
1. Enter the vehicle and turn the ignition switch to ON position. (Alarm
will sound.)
2. Within 10 seconds press and release the valet switch,
The alarm will stop sounding and enter the disarm mode. You can now
start and operate the vehicle normally with the ignition key.
M. VALET MODE:
The valet switch allows you to temporarily bypass all alarm functions,
eliminating the need to hand your transmitter to parking attendants or
garage mechanics. When the system is in Valet Mode, all alarm function
and remote starter functions are bypassed, however the remote panic
feature and remote door locks will remain operational. To use the Valet
Mode, the system must first be disarmed either by using your remote
transmitter, or by operating the Manual override sequence.