Filter
Top Products
. .
19
REMOTE START OPERATION
I. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exists while the system is operating, the
engine will not start or will shut down immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. The emergency brake is released (for Standard Transmission Vehicle)
4. Engine is over-revved. {Tachometer checking type only}
5. The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed.
6. Pressing button twice on the remote transmitter.
7. Move the optional remote start enable toggle switch to OFF position.
(If
installed)
8. If the engine does not start with {3} attempts.
J. DISABLING THE REMOTE START SYSTEM: (If installed)
This feature allows your systems remote starter to be temporarily disabled
to prevent the vehicle from being remote started accidentally. This feature
is useful if the vehicle is being serviced or stored in an enclosed area. To
disable the remote starter, move the optional remote start enable toggle
switch to the OFF position.
LCD REMOTE TRANSCEIVER:
Note: the system may be interfered with by stronger radio frequency,
sources of high voltage electric power lines or obstacles such as tall
buildings, the transmission range may be shorten due to the systems
use of a low powered output frequency.