Filter
Top Products
. .
18
REMOTE START OPERATION
Exit the timer start:
1.Timer start can be exited manually as follows:
Make sure the engine is not running in remote start mode.
2.Turn the ignition key ON. The LED and parking lights will flash (4) times.
The horn chirps (4) times.
Or
1.Press the button twice to remote start the vehicle. As soon as the
vehicle is running and the parking light have turned on or are flashing.
2.Immediately depress the button, then press and hold the button
for 2 seconds. The parking lights will flash (4) times. The siren or horn
chirps (4) times. The vehicle is no longer programmed to start automatically.
G. INTERIOR TEMPERATURE MONITOR
You can monitor through the LCD screen, the present interior
temperature of the passenger compartment before cooling or
heating your vehicle. Press the transceiver SET button first,
within 3 seconds press the ( ) button; the interior temp-
erature will be shown on the LCD screen. This reading may be
higher than actual ambient temperature due to the greenhouse
effect and is relative only the inside vehicle temperature.
H. TO TURN OFF THE REMOTE START:
When the engine is running (in remote start mode), to shut the
engine off: Press the button twice on the remote transmitter.
Move the optional remote start enable toggle switch to the
OFF position. (If installed) Press the brake pedal. Release the
emergency brake. (for Standard Transmission Vehicle) The
vehicle will shut down and turn off the parking lights to indicate
engine has stopped.