. .
11
OPERATION
O. PANIC MODE:
The transmitter can be used as a remote panic switch to
manually trigger the alarm in case emergency.
1. Press and hold the
button for 3 second. The alarm will
immediately sound.
2. During Panic Mode, the normal function of this trans-
mitter button will be suspended. The
and buttons can be
used to lock and unlock the doors (if the option is installed), however
once the
button is pressed, the vehicles starter disable
device, (if installed) will be enable allowing the vehicle to start.
3. To stop the Panic Mode, press and hold the
or buttons on the
transmitter again for 3 seconds, if any transmitter button other than the
or button is pressed and released, the Panic Mode will be turned
off immediately.
4. If the button is not pressed, the alarm will automatically stop after 30
seconds.
P. SYSTEMS STATUS CHECK
When you want to check the systems present status through
the LCD screen, Press the transceiver
button (2) times,
within 3 seconds press the (SET) button. It responds with
one melody sound, the LCD screen should be illuminated.
Note: If there is no responce then you are out of range.
Q. DOME LIGHT SUPERVISION
The alarm has a unique feature that will turn ON your vehicles dome light
as follows:
1. Upon disarming, the interior dome light will remain ON for 30 seconds.
2. If the vehicle is intruded, the interior dome light will flash for the same
duration as the siren.
Note: Turning on the ignition switch or arming the alarm will turn
off the dome light.
R. IGNITION CONTROLLED DOOR LOCK/UNLOCK.
If the vehicles door locks have been interfaced to the security systems
keyless entry, the system will automatically lock the vehicle's doors when
the ignition is turned ON and will unlock the vehicles doors when the
ignition is turned OFF.
