Filter
Top Products
and make use of the engine's
braking effect as well.
Wet brakes
After washing the motor-
cycle, after driving through
water or in the rain, braking can
be delayed due to damp brake
disks and brake pads.
Brake early until the brakes are
dry or braked until dry.
Salt on brakes
The full braking effect can
be delayed if the motor-
cycle is ridden on salt-covered
roads and the brakes are not ap-
plied for some time.
Brake early until the salt layer of
the brake disks and brake pads
has been braked off.
Oil or grease on brakes
Oil and grease on the brake
disks and pads considerably
diminish braking efficiency.
Especially after repair and main-
tenance tasks, make sure that
the brake disks and brake pads
are free of oil and grease.
Dirt or mud on brakes
When the motorcycle is
ridden on loose surfaces
or muddy roads, the brakes may
fail to take effect immediately
because of dirt or moisture on
the disks or brake pads.
Brake early until the brakes are
braked clean.
Parking your
motorcycle
Placing on side stand
If the ground is soft or un-
even, there is no guarantee
that the motorcycle will rest firm-
ly on the stand.
Always check that the ground
under the stand is level and
firm.
Switch off the engine.
Pull handbrake lever.
Hold motorcycle upright and
balanced.
Use your left foot to extend
side stand fully.
The side stand is designed
to support only the weight
of the motorcycle.
Do not lean or sit on the
motorcycle with the side stand
extended.
Slowly lean the motorcycle to
the side until its weight is taken
5
77
z
Riding