Filter
Top Products
Tighten screw 3 on the clamp
with the appropriate torque.
Muffler with ball-joint
clamp on manifold
26 lb/ft (35 Nm)
Position muffler cover 2 and fit
three screws 1.
without center stand
OA
Remove rear wheel stand.
Front wheel stand
Fitting front wheel stand
The BMW Motorrad front
wheel stand is not designed
for holding motorcycles without a
center or other auxiliary stands. A
motorcycle standing on the front
wheel stand and the rear wheel
alone can fall over.
Place the motorcycle on the cen-
ter stand or an auxiliary stand
before lifting it with the BMW
Motorrad front wheel stand.
Use basic stand with tool num-
ber (0 402 241) in combina-
tion with front-wheel adapter
(0 402 243).
without center stand
OA
Place motorcycle on an auxil-
iary stand; BMW Motorrad rec-
ommends BMW Motorrad rear
wheel stand.
Installing rear-wheel stand
( 117).
with center stand
OA
Make sure ground is level and
firm and place motorcycle on
its center stand.
Loosen adjusting screws 1.
Push two mounting pins 2 far
enough apart that front sus-
pension fits between them.
Use locating pins 3 to set front
wheel stand to desired height.
Center front wheel stand rela-
tive to front wheel and push it
against front axle.
8
116
z
Maintenance