Filter
Top Products
3. Connecting the BLACK Wire
The largerBLACK wire( notthe thinblack antennawire ),should have
been connected to ground during the siren module mounting proce-
dure. If you were unsure of the ground reliability of the siren module
mountingbracket, youcanconnectthe eyeletontheend oftheBLACK
wire toanynon paintedbolt onthe firewallor fender,which isthreaded
directly into a metal surface of the vehicle.
2. Connecting the RED Wire
Locate thecourtesy lampfuse. Both sidesof thefuse will indicate+ 12
Volts onthe logic probewhile thefuse is pluggedin. Remove thefuse,
and test the contacts that the fuse plugs into. One of the contacts will
not indicate + 12 Volts. This is where the RED wire will be connected.
Connection Method A;
A. Locate the wire coming from this fuse terminal at the back of the
fusebox.
B. Splicethe RED wire fromthe harness tothis wire, and insulatewith
electrical tape.
Connection Method B;
A. “Fuseclip“terminals, whichwillplugin withthecontactsofthe fuse,
are available at mostelectronics stores. This method of connection
may be easier in some vehicles.
B.Refertothespecificinstructionsincludedwiththefuseclipterminals.
Page 2
COURTESY
LIGHT FUSE
A
SPLICE INTO WIRE AND WRAP
WITH ELECTRICAL TAPE
B
FUSE BOX
FUSE CLIP TERMINAL
(NOT INCLUDED)
RED WIRE
RED WIRE
4. Connecting the DARK BLUE wire
Connectthe DARKBLUEwirefrom themainharnessto theBLUEwire
from thedash mounted L.E.D. Besure to insulate thisconnection with
electrical tape.
5. Connecting the RED wire ( From the L.E.D. )
Splice the Red wire from the dash mounted L.E.D. to the larger RED
wirefromthemainharness.Besuretoinsulatethissplicewithelectrical
tape.
PROGRAMMING THE KEYCHAIN TRANSMITTERS
The two keychaintransmitters that are included with thissystem are a
“ code learning “ type Radio Frequency transmitter, which simply
means that the siren control module will learn and remember the
individual code number of each transmitter. The siren control module
will learn the individual codes of (2) transmitters only.
IMPORTANT !Save these programminginstructions in aplace where
you can easily find them in the future. Whenever the vehicle’s battery
is disconnected for servicing, the transmitters will need to be repro-
grammed.
To Program the Transmitters;
A.The mainharness connectorshould bedisconnected fromthe siren
control module at this step of the installation procedure. If it is not,
unplug the connector.
B. Be sure to have both keychain transmitters in hand, then plug the
main harness connector into the siren control module.
C.Pressandholdthelargerarmingbuttonontransmitternumber1until
the siren sounds one long “ chirp “.
D. Immediately press andhold the larger arming buttonon transmitter
number 2 until the siren sounds one long “ chirp “.
E. Both transmitters should now beprogrammed. You can test this by
pressing the arming button on each transmitter, which will result in
theappropriate“ARMED“or“DISARMED“indicationfromthesiren
module.
IMPORTANT! Ifonlyone transmitterisoperating,repeat theprogram-
ming procedure. Once the harness connector is plugged in, you have
only 15seconds inwhich to programboth transmitters.This short time
window is required in order to provide a high level of security.
SIREN MODULE
BLACK WIRE
NEGATIVE TERMINAL