AT Commands Summary
1-24 G24-L AT Commands Reference Manual April 15, 2008
TCP/IP Commands
+MIPCALL This command creates a wireless PPP connection with the GGSN,
and returns a valid dynamic IP for the G24-L.
Page 3-276
+MIPOPEN This command causes the G24-L to initialize a new socket and open
a connection with a remote side.
Page 3-277
+MIPODM This command causes the G24-L to initialize a new socket in Online
Data Mode and open a connection with a remote side.
Page 3-279
+MIPCLOSE This command causes the G24-L to free the socket accumulating
buffer and disconnect the G24-L from a remote side.
Page 3-282
+MIPSETS This command causes the G24-L to set a watermark in the
accumulating buffer. When the watermark is reached, data is pushed
from the accumulating buffer into the protocol stack.
Page 3-283
+MIPSEND This command causes the G24-L to transmit the data that the
terminal provides, using an existing protocol stack.
Page 3-284
+MIPPUSH This command causes the G24-L to push the data accumulated in its
accumulating buffers into the protocol stack.
Page 3-285
+MIPFLUSH This command causes the G24-L to flush (delete) data accumulated
in its accumulating buffers.
Page 3-286
+MIPRUDP This unsolicited event is sent to the terminal when data is received
from the UDP protocol stack.
Page 3-287
+MIPRTCP This unsolicited event is sent to the terminal when data is received
from the TCP protocol stack.
Page 3-287
+MIPSTAT This unsolicited event is sent to the terminal indicating a change in
link status.
Page 3-288
+MIPXOFF This unsolicited event is sent to the terminal to stop sending data.
Page 3-288
+MIPXON This unsolicited event is sent to the terminal when the G24-L has
free memory in the accumulating buffer.
Page 3-289
+MIPCONF Configure Internal TCP/IP stack.
Page 3-289
+MPING This command will allow verifying IP connectivity to another
remote machine (computer) by sending one or more Internet Control
Message Protocol (ICMP) Echo Request messages.
Page 3-289
+MPINGSTAT This is the unsolicited response that the G24-L sends to the terminal
to inform of ping execution status update and provide summary
statistics of ping request when ping request execution is completed.
Page 3-296
+MSDNS This command sets/reads DNS IP address for each socket.
Page 3-299
+MIPCFF This command sets the Filtering List..
Page 3-301
NOP Compatible
Ignored (Compatible Only) Commands
%C This command is supported for backward compatibility only, and
has no effect.
Page 3-304
Table 1-1: AT Commands (Cont.)
AT Command Description Page
