AT Commands Summary
1-22 G24-L AT Commands Reference Manual April 15, 2008
E This command defines whether the G24-L echoes the characters
received from the user, (whether input characters are echoed to
output).
Page 3-192
X This command defines the data adaptor response set, and the
CONNECT result code format.
Page 3-193
Sn This command reads/writes values of the S-registers, and includes
registers 1-49, 94, 96 (Audio) and 102 (Sleep mode).
Page 3-194
\S This command displays the status of selected commands and
S-registers.
Page 3-197
\G This command sets the use of the software flow control.
Page 3-197
\J This command adjusts the terminal auto rate.
Page 3-197
\N This command displays the type of link.
Page 3-197
+CBAND This command is supported for backward compatibility only, and
has no effect.
Page 3-197
? This command displays the most recently updated value stored in
the S-register.
Page 3-198
&F This command restores the factory default configuration profile.
Page 3-198
Z This command resets the default configuration.
Page 3-199
Sleep Mode Commands
S24 This S-parameter activates/disables the Sleep mode. If the parameter
value is greater than 0, it represent the number of seconds till the
G24-L enters sleep mode.
Page 3-202
S102 This S-register sets the value of the delay before sending the data to
the terminal.
Page 3-203
+MSCTS This command defines the behavior of the CTS line when the G24-L
is in Sleep mode.
Page 3-205
Error Handling Commands
+CMEE This command enables/disables the use of result code +CME
ERROR: <err> as an indication of an error relating to the
functionality of the G24-L.
Page 3-206
+CEER This command returns an extended error report containing one or
more lines of information text, determined by the manufacturer,
providing the reasons for the
call-clearing errors.
Page 3-213
User Interface
+CRSM This command provides limited access to the Elementary Files on
the SIM.
Page 3-216
&V This command displays the current active configuration and stored
user profiles.
Page 3-221
&W This command stores the user profile.
Page 3-222
Table 1-1: AT Commands (Cont.)
AT Command Description Page
