Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-191
The following table shows the V parameters.
Example
ATV?
V: 1
OK
ATV0
0
ATV7
4
ATV1
OK
ATV7
ERROR
Q, Result Code Suppression
This command determines whether to output the result codes. Information text transmitted in
response to commands is not affected by the setting of this parameter.
Table 3-127: V Parameters
<Parameter> Description
<value> 0 Transmits limited headers and trailers, and numeric text.
1 Transmits full headers and trailers, and verbose response text.
The default value is 1.
Command Type Syntax Response/Action Remarks
Set
ATQ<value> OK
or:
+CME ERROR: <err>
The set commands sets whether or not
to output result codes.
Read
ATQ? <current value>
The Read command reads the current
setting for result code suppression.
Test The Test command for Q is not
defined, and therefore is not supported
by the G24-L. The G24-L returns an
error.
