GPRS
3-290 G24-L AT Commands Reference Manual April 15, 2008
parameters before socket activation or when the socket is in active state. Configuration values
will be stored in G24-L until power circle.
The following table shows the +MIPCONF parameters.
Command Type Syntax Response/Action Remarks
Set
AT+MIPCONF=<
socket>[,[<retr_n
um>],[<min_TO>
],[<max_TO>],[<
max_close_delay>
][,<is_nack_ind_r
eq>]]
OK
or:
+CME ERROR: <err>
The Set updates TCP
stack configuration
parameters.
Read
+MIPCONF? +MIPCONF:
1,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
<CR><LF>
+MIPCONF:
2,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
<CR><LF>
+MIPCONF:
3,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
<CR><LF>
+MIPCONF:
4,<retr_num>,<min_TO>,<max_TO>,
<max_close_delay>,<is_nack_ind_req>
The read command
returns current
settings of TCP stack
parameters.
Test
+MIPCONF=? +MIPCONF:
(1-4),(1-5),(1-10),(10-600),(1-75),(0-2)
The Test command
returns the possible
parameters values.
Time values can be
inserted with
resolution of 100
milliseconds.
Table 3-206: +MIPCONF Parameters
Parameter Description
< socket > Number of configured TCP socket (1 to 4)
< retr_num > Number of retransmissions (1 to 5)
< min_TO > Bottom limit to retransmit timeout ( 100 ms to 1 sec.)
<max_TO> Upper limit to retransmit timeout (1 sec. to 60 sec.)
