Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-79
The following table shows the +CSCA parameters.
Example
AT+CSCA="4252833433"
OK
AT+CSCA?
+CSCA: "4252833433",129
OK
+CSMP, Set Text Mode Parameters
This command is a basic command and is used to select values for additional parameters needed
when SM is sent to the network or placed in storage when TEXT mode is selected.
Command
Type
Syntax Response/Action Remarks
Set
+CSCA=<sca>[,<tosca>] OK
or:
+CMS ERROR: <err>
The Set command sets the service
center address.
Read
+CSCA? +CSCA: <sca>,<tosca>
Test The Test command for +CSCA is not
defined by ETSI, and therefore is not
supported by the G24-L. The G24-L
returns an error.
Table 3-45: +CSCA Parameters
<Parameter> Description
<sca> Service Center Address
<tosca> Type of Service Center Address is the current address format setting
Command
Type
Syntax Response/Action Remarks
Set
+CSMP=[<fo>[,<vp>
[,<pid>[,<dcs>]]]]
OK
or:
+CMS ERROR: <err>
The set command selects values for
additional parameters needed when SM is
sent to the network or placed in storage
when text format message mode is
selected.
