2. MACHINING PARAMETERS
2.2 Control Parameters
II - 10
# Item Contents Setup range (unit)
8109 HOST LINK Specify whether to enable computer link B instead
of the RS-232C port.
0: Disable computer link B to enable normal
RS-232C communication.
1: Enable computer link B to disable normal
RS-232C communication.
0/1
8110 G71/G72 POCKET Set the pocket machining if there is a dimple
(pocket) in the rough cutting cycle (G71, G72)
finishing program.
0: Pocket machining OFF
1: Pocket machining ON
0/1
8111 Milling Radius Select the diameter and radius of the linear axis for
cylindrical/polar coordinate interpolation.
0: All axes radius value command
1: Each axis setting (follows #1019 dia diameter
designated axis)
Note: This parameter is valid only in the
cylindrical/polar coordinate interpolation
mode.
0/1
8112 DECIMAL PNT-P 0: The decimal point command for G04 address
P is invalidated.
1: The decimal point command for G04 address
P is validated.
0/1
8113 MillingInitG16 Not used.
8114 MillingInitG19 Not used.
