5. BASE SPECIFICATIONS PARAMETERS
II - 78
# Items Details Setting range (unit)
1513 stapM M code for
synchronous
tap selection
Select the synchronous tap mode using the
miscellaneous function code of the value set in this
parameter. The M function command can be issued
immediately before the tap command or in the same
block. This function is valid only when 1 is set in
#1272 ext08/bit 1 (Enable/disable M-function
synchronous tap cycle).
Note: Do not use M00, 01 02, 30, 98, and 99.
0 to 99999999
1514 expLinax Not used.
1515 expRotax Not used.
1516 mill_ax Milling axis
name
Set the name of the rotary axis used in cylindrical
interpolation or polar coordinate interpolation. Only
one rotary axis can be set.
When there is no E command in issuing the cylindrical
interpolation or polar coordinate interpolation
command, this parameter will be followed.
A to Z
1517 mill_C Milling
interpolation
hypothetical
axis name
Select the hypothetical axis command name for pole
coordinate interpolation.
When there is no D command in issuing the G12.1
command, this parameter will be followed.
0: Y axis command
1: Command rotary axis name.
0/1
1518 polm Not used.
1519 pols Not used.
1520
(PR)
Tchg34 Additional
axis tool
compensa-
tion operation
Select whether to carry out the additional axis' tool
compensation function with the 3rd axis or 4th axis.
0: Select 3rd axis.
1: Select 4th axis.
0/1
1521 C_min Not used.
1522
(PR)
C_axis Not used.
1523 C_feed Not used.
1524 C_type Not used.
