A SERVICE OF

logo

Open as PDF
next previous
2. MACHINING PARAMETERS
2.5 Tool Measurement Parameters
II - 15
2.5 Tool Measurement Parameters
Set up the parameter of the tool (touch tool sensor), etc, used for measurement.
# Item Contents Setup range (unit)
8701 Tool length Set the length to the end of the touch tool. ±99999.999 (mm)
8702 Tool Dia Set the spherical diameter of the touch tool
end.
±99999.999 (mm)
8703 OFFSET X Set the spindle center deviation amount from
the touch tool center in the X axis direction.
±99999.999 (mm)
8704 Y Set the spindle center deviation amount from
the touch tool center in the Y axis direction.
±99999.999 (mm)
8705 RETURN Set the return distance to contact the touch tool
against the workpiece again.
±99999.999 (mm)
8706 FEED Set the feedrate when contacting the touch
tool against the workpiece again.
1 to 60000 (mm/min)