5. BASE SPECIFICATIONS PARAMETERS
II - 33
# Items Details Setting range (unit)
1081 Gmac_P Give priority
to G code
parameter
Specify the G code priority relationship during the
macro call with the G command.
0: G code used in system is priority.
1: Registered G code for call out is priority.
0/1
1082 Geomet
(For L
system
only)
Geometric Specify whether to use the geometric I or IB
function.
0: Do not use.
1: Use only geometric I.
2: Use geometric I and IB.
With geometric, specific address codes are used for
exclusive meanings. Thus, if A or C is used for the
axis address or 2nd miscellaneous command code,
the A used for the axis address may function as the
geometric's angle designation. Take special care
when designating the axis name, etc., when using
this function.
0/1/2
1084 RadErr Arc error Specify the tolerable error range when a deviation
occurs in the end point and center coordinate in the
circular command.
0 to 1.000 (mm)
1085 G00Drn G00 dry run Specify whether to apply dry run (feed with manual
setting speed instead of command feedrate) to the
G00 command.
0: Do not apply to G00. (move at rapid traverse
rate)
1: Apply to G00. (move at manual set feedrate)
0: Do not apply to
G00
1: Apply to G00
1086 G0lntp G00
non-interpol
ation
Specify the G00 movement path type
0: Move linearly toward the end point.
(interpolation type)
1: Move to the end point of each axis at the rapid
traverse feedrate for each axis.
(non-interpolation)
0/1
1087 G96_G0 Constant
surface
speed
control by
rapid
traverse
feed
command
Specify how to handle the cycle speed for the G00
command when using the constant surface speed
control function.
0: Calculate the cycle speed constantly even
during G00 movement.
1: Calculate the cycle speed at the block end
point in the G00 command.
0/1
1088 G30SL Disable G30
soft limit
Specify how to handle the soft limit during G30 (2nd,
3rd and 4th reference point return) movement.
0: Soft limit valid during G30 movement
1: Soft limit invalid during G30 movement
0: Soft limit valid
1: Soft limit invalid
1089 Cut_RT Short cut for
rotary axis
Specify how to handle the short cut control for the
rotary axis (#1017 rot is set to 1).
0: No short cut (move toward end point)
1: Use short cut (when using the absolute value
command‚ move in the direction where the
movement amount will be 180° or less)
0: No short cut
1: Use short cut
