Filter
Top Products
Periodic maintenance
66
5. Remove the bulb.
6. Install the new bulb, and then hook the
bulb holder onto the headlight unit.
CAUTION:
ECS00620
Keep oil and your hands away from the
glass part of the bulb or its life and illumi-
nation will be affected.
If the glass is oil stained, thoroughly clean
it with a cloth moistened with alcohol or
lacquer thinner.
7. Install the bulb holder cover, and then
connect the headlight coupler.
8. Install the shroud.
ESU12861
Adjusting the headlight beams
1. Remove the shroud. (See page 43 for re-
moval procedures.)
2. Turn the headlight beam adjusting screw
in or out to adjust the headlight beams.
To lower the headlight beams, turn the
headlight beam adjusting screw in direc-
tion (a). To raise the headlight beams,
turn the headlight beam adjusting screw
in direction (b).
3. Install the shroud.
ESU12290
Fittings and fasteners
Check the tightness of the fittings and fasten-
ers.
Tighten in proper sequence and torque if nec-
essary.
ESU12300
Battery
This snowmobile is equipped with a sealed-
type (MF) battery, which does not require any
maintenance. There is no need to check the
electrolyte or to add distilled water.
To charge the battery
Have a Yamaha dealer charge the battery as
soon as possible if it seems to have dis-
charged. Keep in mind that the battery tends
to discharge more quickly if the snowmobile is
equipped with electrical accessories.
1. Bulb holder
Bulb type:
Halogen bulb
1. Do not touch the glass part of the bulb.
1. Headlight beam adjusting screw
U8GL10E0.book Page 66 Friday, May 18, 2007 3:17 PM