Filter
Top Products
Control functions
17
NOTE:
When the brake lever is operated, the brake
light will illuminate.
CAUTION:
ECS00060
Make sure that the brake lever end does
not project out over the handlebar end.
This will help prevent brake lever damage
when the snowmobile is placed on its side
for service.
The brake lever is equipped with a position
adjuster.
To adjust the brake lever position:
1. Loosen the locknut.
2. While lightly pushing the brake lever in di-
rection (a), finger tighten the adjusting
bolt to set the brake lever to the desired
position.
3. Tighten the locknut securely after adjust-
ing the brake lever.
ESU10580
Parking brake lever
When parking the snowmobile or starting the
engine, apply the parking brake by moving the
parking brake lever to the left.
To release the parking brake, move the park-
ing brake lever to the right.
WARNING
EWS00060
● Always set the parking brake before at-
tempting to start the engine.
● Never run the snowmobile with the park-
ing brake applied. This may overheat the
brake disc and reduce braking ability.
1. Brake lever
1. Locknut
2. Adjusting bolt
1. Parking brake lever
U8GL10E0.book Page 17 Friday, May 18, 2007 3:17 PM