Filter
Top Products
Periodic maintenance
57
9. Rotate the secondary sliding sheave
clockwise and push it so that it separates
from the secondary fixed sheave.
10. Install the V-belt between the secondary
sliding and fixed sheaves.
11. Install the drive guard, and then install the
left side cover and the shroud.
ESU12830
Drive chain housing
WARNING
EWS00430
The engine, oil tank, brake disc, and cool-
ant hoses will be very hot after the engine
has been run. Avoid contact while they are
still hot with any part of your body or cloth-
ing during inspection or repair.
To check the drive chain housing oil level
1. Place the snowmobile on a level surface.
2. Remove the shroud and the right side
cover. (See page 43 for removal proce-
dures.)
3. Remove the dipstick, wipe it off with a
clean rag, and then screw it back into the
filler hole.
4. Remove the dipstick and check that the
oil level is within the range shown at the
bottom of the dipstick. If the oil does not
reach the bottom of the dipstick, add suf-
ficient oil of the recommended type to
raise it to the correct level.
1. Secondary sliding sheave
2. Secondary fixed sheave
1. V-belt
1. Dipstick
1. Oil level range (FX10RT / FX10MT)
2. Oil level range (FX10 / FX10RTR /
FX10RTRA / FX10MTR / FX10MTRA)
U8GL10E0.book Page 57 Friday, May 18, 2007 3:17 PM