Filter
Top Products
Control functions
28
WARNING
EWS00170
Never adjust the control rods beyond the
maximum range indicated on the rods with
red paint.
3. Tighten the locknut while holding the con-
trol rod adjusting nut in place.
CAUTION:
ECS00800
The left and right adjusting nuts must be
set to the same position. Uneven settings
can cause poor handling and loss of sta-
bility.
1. Locknut
2. Control rod adjusting nut
1. Red paint area
2. Adjustable range
3. Standard position
Locknut tightening torque:
25 Nm (2.5 m·kgf, 18 ft·lb)
U8GL10E0.book Page 28 Friday, May 18, 2007 3:17 PM