Filter
Top Products
Rev.: 20120307
Platform: DBALL
Firmware: CHRYSLER Remote Start Ready Installation
© 2012 Directed.All rights reserved.
Installation Type 2b (without T-Harness)
Page 8
10
DBALL
Programming button
LED
4
14
12
2
Twisted pair in the kick panel
White/Orange
White/Gray, White
or White/Pink
RF
5: White/Orange: FTCAN High
6: White: FTCAN Low
2: Green/Black: (-) Parking Lights*
(-) Driver door pin
Purple wire in
driver kick panel
10: Yellow/Black: RAPOFF
8: Violet/Green: MUX*Parking Light
9: Violet/Brown: Parking Light MUX*
Hood Pin
Neutral Safety Switch
6: White/Black: (-) Hood
See page 9 for
wiring information
Important!
The Hood Pin and Neutral Safety Switch are mandatory security devices, but are NOT supplied with the DBALL.
TX
(-) Ground
RX
(+) 12v
Wires are listed by pin numbers. This display is not representative of connector pin layouts, which are often stacked.
(+) Ignition
CAN High
CAN Low
1
6
12
7
Connector side view
at ignition switch
3: Tan/Black:HSCAN High
4: Tan:HSCAN Low
Ignition
Barrel
8: Yellow
9: Orange/Yellow
7: Brown: (+) 12v(+) 12v
14: Black: (-) Ground(-) Ground
13: Red: (+) 12v(+) 12v
The XL202 and antenna are not included and MUST be
purchased separately.
optional
LED
OR
Programming
Button
4
4
XL202
Antenna
(+)12v
TX
(-) Ground
RX
SmartStart is not included. It MUST be purchased
separately.
optional and
You can either connect to an XL202 module
or to a SmartStart module.
LED
SmartStart
Configuration Wires (Gray & White)
Connect Gray wire to (-) Ground
5 pins
D2D (4 pins, white)
4 pins
2 pins
(+)12v
TX
(-) Ground
RX
*See Parking Lights wiring reference chart for the appropriate Parking Lights configuration.
OR*
XOVER
CABLE