Filter
Top Products
Rev.: 20120307
Platform: DBALL
Firmware: CHRYSLER Remote Start Ready Installation
© 2012 Directed.All rights reserved.
Page 22
Feature and Option List
To enter feature programming routine
Accessing another feature
Once a feature is programmed
Turn the ignition ON, then OFF.
, press and HOLD the programming button until the LED turns ON orange (after 3 seconds). Release the
Programming button.
The LED will flash green once slowly to indicate the feature number is 1. After a short delay, the LED flashes red rapidly to indicate
the current option of feature 1 (i.e. 1x green followed by 1x red indicates feature 1 is set to option 1). The flashing sequence will
repeat until a new command is entered.
Press and release the programming button a number of times to advance from the current feature to the next desired .
The LED flashes green slowly the number of times equal to the feature number. After a short delay, the LED flashes red rapidly to
indicate the current option of the current feature.
Other features can be programmed.
The feature programming can be exited.
Within 5 seconds
When the maximum number of features or options is reached, the LED will start flashing again from the first feature or
option.
-
-
-
-
-
-
-
Changing feature options
Press the lock/arm or unlock/disarm button on aftermarket transmitter to change the option of the selected feature.
The LED flashes red rapidly the number of times equal to the current option number. After a short delay, the LED flashes green
slowly the number of times to indicate the current feature.
-
-
The flashing sequence will repeat until a new command is entered.
feature
The flashing sequence will repeat until a new command is entered.
Exiting feature programming
-
-
No activity for 30 seconds; after 30 seconds, the LED will turn ON for 2 seconds to confirm the end of the programming
sequence.
OR
Press and HOLD the programming button for 3 seconds. After 3 seconds, the LED will turn ON for 2 seconds to confirm
.
orange
orange the
end of the programming sequence
Feature Programming
Features Operation Option
1
RF Output Type**
Activate this feature whenever an external
RFTD module is used (i.e. Directed
SmartStart
TM
, XL201 or XL202).
No RF Output*
RFTD Output
2Trunk
No Option
Trunk*
Right Sliding Door
Left Sliding Door
3Aux1
No Option
Trunk
Passenger Sliding Door*
Driver Sliding Door
4Aux2
No Option
Trunk
Passenger Sliding Door
Driver Sliding Door*
* Default option
Note: Features 2, 3 and 4 are programmable triggers.
Programming
Button
** Important
RFTD Output
The RF Output Type function must be
set to to enable the Remote
Start Ready (RSR) mode.
It will automatically be configured on the web
when flashed with the selected D2D_TYPE
D2D (RFTD) D2D (SmartStart).or
Any module reset will reset to default
option.
It is recommended to configure all features and options listed below on the when the module is being flashed;
however, a manual configuration is possible using the information found on this page.
web