Filter
Top Products
Rev.: 20120307
Platform: DBALL
Firmware: CHRYSLER Remote Start Ready Installation
© 2012 Directed.All rights reserved.
4
Press and hold the Programming Button. The LED
turns ON solid green OR orange for 3 seconds and
then turns OFF. Release the Programming button.
& &&
5
Turn the key to the OFF position and remove it from the ignition barrel.
Page 19
3
Insert the key into the ignition barrel and turn it to the ON position.
It is important to wait for the LED to start flashing green.*
* Refer to the LED Diagnostics section on page 23 for troubleshooting
if the LED does not flash green within 15 seconds.
Off
Press & Hold
Release
&
Flashes
KeyIN
OFF
START
ON
KeyOUT
OFF
START
IGN
Solid
Solid
or
Module Programming for Installation Types 1 to 4 (WITHOUT Factory Keyless)
or
DBALL Module Programming
1
2
Connect the SmartStart or XL202 unit into the D2D port of the prior to
connecting the power.
DBALL
10-pin
D2D
Refer to the LED Diagnostics section on page 23 for more information and for troubleshooting purposes.
Important! If connected to a SmartStart, please ensure that its Gray wire is connected to a ground source or the D2D
communication between the two (2) modules will NOT work.
Connect the 10-pin, 12-pin and 14-pin
harnesses to DBALL, then wait until the
LED turns ON solid red or flashes orange.
10-pin
D2D
1
st
12-pin
14-pin
2
nd
3
rd
&
Solid
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
: Before connecting either the XL202 or SmartStart module to DBALL, it is important to ensure that the
enabled on DBALL using XpressVIP. This selection is done by:
1. Going to www.xpresskit.com.
2. Selecting the make, model and year of the vehicle.
3. On the search result page, click on the button.
4. The flash page will then be displayed listing the D2D type settings. Make your selection and flash the module.
To use DBALL with an:
RF Kit and XL202, must be selected.
SmartStart (Revision B),
Note
Flash it
D2D (RFTD)
proper
communication protocol is
must be selected.
A reset will erase all the settings configured on the module using the web tool (see the above instructions). Therefore, if you reset
before executing the programming sequence, you will HAVE to re-flash the module in order to re-configure the desired options.
§
§
D2D (SmartStart)
Warning against resetting the DBALL module before executing the programming sequence!
Flashes