Filter
Top Products
Rev.: 20120307
Platform: DBALL
Firmware: CHRYSLER Remote Start Ready Installation
© 2012 Directed.All rights reserved.
30
86
85
87
87a
Installation Type 1b (without T-Harness)
Page 5
10
DBALL
RF
Programming button
LED
4
14
12
2
10: Yellow/Black: RAPOFF
8: Violet/Green: MUX*Parking Light
9: Violet/Brown: Parking Light MUX*
Important!
The Hood Pin and Neutral Safety Switch are mandatory security devices, but are NOT supplied with the DBALL.
(-) Driver door pin
Purple wire in
driver kick panel
Wires are listed by pin numbers. This display is not representative of connector pin layouts, which are often stacked.
Hood Pin
Neutral Safety Switch
6: White/Black: (-) Hood
See page 6 for
wiring information
TX
(-) Ground
RX
(+) 12v
Tovehicle’s
(+) Parking Lights
White/Purple
Fuse 15A
+12v
Ignition
Barrel
(+) Ignition
CAN High
CAN Low
1
6
12
7
Connector side view
at ignition switch
2: Green/Black: (-) Parking Lights via Relay*
3: Tan/Black:HSCAN High
4: Tan:HSCAN Low
8: Yellow
9: Orange/Yellow
7: Brown: (+) 12v(+) 12v
14: Black: (-) Ground(-) Ground
13: Red: (+) 12v(+) 12v
The XL202 and antenna are not included and MUST be
purchased separately.
optional
LED
OR
Programming
Button
4
4
XL202
Antenna
(+)12v
TX
(-) Ground
RX
SmartStart is not included. It MUST be purchased
separately.
optional and
You can either connect to an XL202 module
or to a SmartStart module.
LED
SmartStart
Configuration Wires (Gray & White)
Connect Gray wire to (-) Ground
5 pins
D2D (4 pins, white)
4 pins
2 pins
(+)12v
TX
(-) Ground
RX
OR*
*See Parking Lights wiring reference chart for the appropriate Parking Lights configuration.
XOVER
CABLE
ONLYconnect for
Dodge Journey.