Filter
Top Products
Rev.: 20120307
Platform: DBALL
Firmware: CHRYSLER Remote Start Ready Installation
© 2012 Directed.All rights reserved.
Module Programming for Installation Types 1 to 4 (WITH Factory Keyless)
Page 18
DBALL Module Programming
1
2
Connect the SmartStart or XL202 unit into the D2D port of the prior to
connecting the power.
DBALL
Connect the 10-pin, 12-pin and 14-pin
harnesses to DBALL, then wait until the
LED turns ON solid red or flashes orange.
10-pin
D2D
10-pin
D2D
1
st
12-pin
14-pin
2
nd
3
rd
33
4
5
Turn the key to the OFF
position and remove it
from the ignition barrel.
Press LOCK or UNLOCK on the
. The LED turns
ON solid green OR orange for 3 seconds
and then turns off.
factory transmitter
or
&
&
&
Insert the key into the ignition barrel and turn it
to the ON position.
Key Ignition Push-to-Start (PTS) Ignition
It is important to wait for the LED to start flashing
green. Refer to the LED Diagnostics section on
page 23 for troubleshooting if the LED does not
flash green within 15 seconds.
or
or
Solid Solid
Flashes
Off
Solid
Flashes
&
Flashes
KeyIN
OFF
START
ON
KeyOUT
OFF
START
IGN
4
Press the Push-to-Start
(PTS) button once more
to turn the ignition OFF.
1X
ENGINE
START
STOP
PUSH
It is important to wait for the LED to start flashing
green. Refer to the LED Diagnostics section on
page 23 for troubleshooting if the LED does not
flash green within 15 seconds.
Press the Push-to-Start (PTS) button twice to
turn the ignition ON.
Important: Do NOT press the brake pedal.
2X
ENGINE
START
STOP
PUSH
Do NOT
press the
brake pedal
Refer to the LED Diagnostics section on page 23 for more information and for troubleshooting purposes.
Important! If connected to a SmartStart, please ensure that its Gray wire is connected to a ground source or the D2D
communication between the two (2) modules will NOT work.
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
: Before connecting either the XL202 or SmartStart module to DBALL, it is important to ensure that the
enabled on DBALL using XpressVIP. This selection is done by:
1. Going to www.xpresskit.com.
2. Selecting the make, model and year of the vehicle.
3. On the search result page, click on the button.
4. The flash page will then be displayed listing the D2D type settings. Make your selection and flash the module.
To use DBALL with an:
RF Kit and XL202, must be selected.
SmartStart (Revision B),
Note
Flash it
D2D (RFTD)
proper
communication protocol is
must be selected.
A reset will erase all the settings configured on the module using the web tool (see the above instructions). Therefore, if you reset
before executing the programming sequence, you will HAVE to re-flash the module in order to re-configure the desired options.
§
§
D2D (SmartStart)
Warning against resetting the DBALL module before executing the programming sequence!
PANIC