Filter
Top Products
Rev.: 20120307
Platform: DBALL
Firmware: CHRYSLER Remote Start Ready Installation
© 2012 Directed.All rights reserved.
Installation Type 4b (without T-Harness)
Page 14
Wires are listed by pin numbers. This display is not representative of connector pin layouts, which are often stacked.
Important!
The Hood Pin and Neutral Safety Switch are mandatory security devices, but are NOT supplied with the DBALL.
10
DBALL
Programming button
LED
4
14
12
2
3: Tan/Black:HSCAN High
CAN Low, Pin 7
CAN High, Pin 6
18
(+) Ignition, Pin 3
(+) Start, Pin 4
Violet/Brown, Pin 2
1
Connector side view
at ignition switch
Connector side view
at ignition switch
RF
8: Violet/Green: Multiplex Output
9: Violet/Brown: Multiplex Output
4: Tan:HSCAN Low
TX
(-) Ground
RX
(+) 12v
The XL202 and antenna are not included and MUST be
purchased separately.
optional
LED
OR
Programming
Button
4
4
XL202
Antenna
(+)12v
TX
(-) Ground
RX
SmartStart is not included. It MUST be purchased
separately.
optional and
You can either connect to an XL202 module
or to a SmartStart module.
LED
SmartStart
Configuration Wires (Gray & White)
Connect Gray wire to (-) Ground
5 pins
D2D (4 pins, white)
4 pins
2 pins
(+)12v
TX
(-) Ground
RX
14: Black: (-) Ground(-) Ground
13: Red: (+) 12v(+) 12v
8: Yellow: (+) Ignition
11: Yellow/Red: (+) Start
2: Green/Black: (-) Parking Lights
7: Brown: (+) 12v(+) 12v
Hood Pin
Neutral Safety Switch
6: White/Black: (-) Hood
12: Brown/Red: (+) 12v
(+) 12v
(+) Parking Lights
See page 15 for
wiring information.
30
86
85
87
87a
Tovehicle’s
(+) Parking Lights
Fuse 15A
+12v
XOVER
CABLE
5or6