Filter
Top Products
Rev.: 20120307
Platform: DBALL
Firmware: CHRYSLER Remote Start Ready Installation
© 2012 Directed.All rights reserved.
10
DBALL
Programming button
LED
4
14
12
2
10: Yellow/Black: RAPOFF
RF
(-) Driver door pin
Purple wire in
driver kick panel
Installation Type 3a (with T-Harness)
Page 10
TX
(-) Ground
RX
(+) 12v
The XL202 and antenna are not included and MUST be
purchased separately.
optional
LED
OR
Programming
Button
4
4
XL202
Antenna
(+)12v
TX
(-) Ground
RX
SmartStart is not included. It MUST be purchased
separately.
optional and
You can either connect to an XL202 module
or to a SmartStart module.
LED
SmartStart
Configuration Wires (Gray & White)
Connect Gray wire to (-) Ground
5 pins
D2D (4 pins, white)
4 pins
2 pins
(+)12v
TX
(-) Ground
RX
Important!
The Hood Pin and Neutral Safety Switch are mandatory security devices, but are NOT supplied with the DBALL.
Wires are listed by pin numbers. This display is not representative of connector pin layouts, which are often stacked.
18
Connector side view
at ignition switch
2: Green/Black: (-) Parking Lights
Hood Pin
Neutral Safety Switch
6: White/Black: (-) Hood
CHTHD2
(optional)
30
86
85
87
87a
Tovehicle’s
(+) Parking Lights
Fuse 15A
+12v
XOVER
CABLE
See page 12 for
wiring information