Filter
Top Products
PROGRAMMING
24 ME00070B TMS7 SERIES
Default Setting: 0
Description: Allows function adjustments be returned to the
factory defaults.
Adjustment: Set to 50 to load default parameter settings.
7.4 Operation
Once installed, wired and programmed according to the
instructions earlier in this manual the TMS7 can be operated.
Local control panel.
1. Numeric LED Display: The information being displayed is
indicated by the LEDs to the right of the display. During
operation either motor current (Amps) or the calculated
motor temperature (%) can be displayed. Use the <UP> or
<DOWN> keys select what information is displayed. In the
event of a trip state the relevant trip code will be shown.
If motor current exceeds the maximum current able to be
shown on the numeric display, the display will show
dashes.
2. Starter Status LEDs:
Start: Voltage is being applied to the motor terminals.
Run: Full voltage is being applied to the motor terminals.
Trip: The TMS7 has tripped.
Remote: The TMS7 is in remote control mode.
3. Operational Push Buttons: These push buttons can be
used to control TMS7 operation when in local control
mode. The <LOCAL/REMOTE> push button can be used
to switch between local and remote control.
CAUTION
NOTE:
When control power is applied to the TMS7 it may
be in either local or remote control mode according
to the mode it was in when control power was
removed. The factory default is local control.