Filter
Top Products
GE863-GPS Software User Guide
1vv0300724 Rev. 2 - 24/01/07
- Data coding Scheme as defined by GSM 3.38 – in numerical format
The DCS is an 8-bit parameter reported as an integer, the default value is 0, otherwise
for simplicity, we report only the most useful DCS, for further Schemes refer to GSM 3.38
b7 b6 b5 b4 b3 b2 b1 b0
1 1 1 1 0 Alpha
bet
Class
where
Alphabet
0 - default Alphabet
1 - 8 bit
Class
0 0 - Class 0
0 1 - Class 1
1 0 - Class 2
1 1 - Class 3
TIP: The default value for DCS = 0 represents the default SMS sent by a mobile. If you don't
need any particular data coding scheme use DCS=0.
NOTE: Not all the DCS combinations described in the GSM 3.38 are supported, both by the
network and by the Telit GE863-GPS. Some features may be not implemented at network level
or at device level, resulting in a +CMS ERROR: 303 (operation not supported) result code. If
this happens then use a different DCS.
• send command AT+CSMP=<fo>,<vp>,<pid>,<dcs><cr>
where:
<fo>: Message format
<vp>: Validity Period
<pid>: Protocol Identifier
<dcs>: Data coding Scheme
wait for
OK
•
For example:
1- Let's assume you want to set the SMS parameters to the values:
- Message Format:
- SMS submit
- don't reject duplicates
- VP Format integer (relative)
- status report not requested
- No Header on PDU
- Reply path not set
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 62 of 109