Filter
Top Products
GE863-GPS Software User Guide
1vv0300724 Rev. 2 - 24/01/07
5.5 Checking GPS device functionality
After a proper power on the device is ready to receive AT commands on the MODEM serial port.
The GPS receiver also will be automatically powered on and it will start the scan of the available GPS
signals.
On the NMEA serial port (default 4800 bps, 8, n, 1) there must be presence of the NMEA sentences.
5.5.1 Controlled mode
The GE863-GPS is by factory default set to controlled mode.
With the command AT$GPSD=<device type> is possible to set this configuration.
Parameter:
<device type>
0 - none; the serial port is not connected to GPS device
2 - serial port connected to GPS serial port: controlled mode (default)
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 100 of 109