Filter
Top Products
GE863-GPS Software User Guide
1vv0300724 Rev. 2 - 24/01/07
AT+CLCK=OX,1,1234<cr>
response:
OK
3.2.4.7 Unbarring all the Calls
• Send command AT+CLCK=AB,0,<pwd><cr>
where:
<pwd> is the network password required to change facility status
• wait for response:
Response Reason Action
OK Barring is now disabled all calls will be allowed
(unbarred)
ERROR some error occurred Enable the extended error
codes report (see par.2.5.2.1)
and retry.
+CME ERROR: 4 operation not supported, the
service required is not available
Check command syntax
+CME ERROR: 30 no network service Check for registration (see par.
2.5.3.1) and signal strength.
+CME ERROR: 16 wrong network password check network password and
retry
For example:
1- Let's assume you want to disable all the barring services you might have previously activated and
the network password of your operator is 0000:
command:
AT+CLCK=AB,0,0000<cr>
response:
OK
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 50 of 109