Filter
Top Products
GE863-GPS Software User Guide
1vv0300724 Rev. 2 - 24/01/07
command:
AT#MONI?<cr>
Answer:
#MONI: Cc: 010 Nc: 03 BSIC:23 RxQual:7 LAC:0001 Id:0001 ARFCN: 60 PWR: -83 dBm TA:0
OK
In this case the mobile is registered on the network whose Country code is 010 and Network operator
code is 03, the signal strength is -83dBm (MMI may indicate 4 antenna bars as reported on the table
5). The other information received is strictly technical and should not be given to the user.
The values reported are random and have no meaning they are used only to explain command usage.
NOTE: This command should be used only to gather information on network name and signal
strength, to check if mobile is registered or is looking for a suitable network to register to, use
always the +CREG command. This is due to the fact that if the network signal is too weak and
mobile looses the registration, until a new network is found the #MONI command reports the
last measured valid values and not the real ones.
The TA (timing advance parameter) is valid only during a call.
TIP: To properly use this feature, check network registration with command +CREG as seen on
par. 2.5.3.1 and when mobile is registered query the mobile for network operator name and
signal strength with #MONI command.
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 20 of 109