Filter
Top Products
4. To match additional transmitters
at this time, repeat Step 3.
Each vehicle can have a
maximum of eight transmitters
matched to it.
5. To exit the programming mode,
you must cycle the key to
LOCK/OFF.
Compass Zone Setting
This display allows for setting the
compass zone. See DIC Compass
on page 3-40 for more information.
Compass Recalibration
This display allows for calibrating
the compass. See DIC Compass on
page 3-40 for more information.
ECO (Economy) Light On/Off
This display allows you to turn the
ECO light in the cluster on and
off. See Fuel Economy Light
on page 3-35 for more information.
Press the vehicle information
button until PRESS
V SET ECO
displays. This display will only
be available when the vehicle is in
P (Park). Once in the display,
press the set/reset button to select
ON or OFF.
Blank Display
This display shows no information.
DIC Compass
Your vehicle may have a
compass in the Driver Information
Center (DIC).
Compass Zone
The zone is set to zone eight upon
leaving the factory. Your dealer/
retailer will set the correct zone for
your location.
Under certain circumstances, such
as during a long distance
cross-country trip or moving to a
new state or province, it will
be necessary to compensate for
compass variance by resetting the
zone through the DIC if the zone
is not set correctly.
Compass variance is the difference
between the earth’s magnetic
north and true geographic north. If
the compass is not set to the
zone where you live, the compass
may give false readings. The
compass must be set to the variance
zone in which the vehicle is
traveling.
To adjust for compass variance, use
the following procedure:
Compass Variance (Zone)
Procedure
1. Do not set the compass zone
when the vehicle is moving.
Only set it when the vehicle is in
P (Park).
Press the vehicle information
button until PRESS
V TO SET
COMPASS ZONE: ## displays.
3-40 Instrument Panel