Porter-Cable PCG4000 Automobile Parts User Manual


 
29 - ENG
ters are fully guaranteed against defective material and workmanship. We cannot
guarantee repairs made or attempted by others.

North, Jackson, Tennessee 38305 - Attention: Product Service. Be sure to include
all of the information shown on the nameplate of your tool (model number, type,
serial number, etc.).
ACCESSORIES
Since accessories, other than those offered by PORTER-CABLE,
have not been tested with this product, use of such accessories with this tool could
be hazardous. To reduce the risk of injury, only PORTER-CABLE recommended
accessories should be used with this product.
A complete line of accessories is available from your PORTER-CABLE Factory
Service Center or a PORTER-CABLE Authorized Warranty Service Center. Please
visit our Web Site www.deltaportercable.com for a catalog or for the name of your
nearest supplier.
TROUBLESHOOTING GUIDE
This section provides a list of the more frequently encountered malfunctions,
their causes and corrective actions. The operator or maintenance personnel can
perform some corrective actions, and others may require the assistance of a
qualified PORTER-CABLE technician or your dealer.
Problem Code
Engine will not start ........................... 1, 2, 3, 4, 14, 15, 16, 17, 18, 19, 20, 21, 27
No electrical output ............................................................... 5, 6, 7, 8, 9, 10, 12, 13
NOTE: If there is still no power at the receptacles, Contact a Customer Care
Center.
Repeated main breaker tripping ......................................................................... 9, 10
Generator overheating ........................................................................................9, 11
Engine does not continue to run after starting ..1, 2, 3, 14, 16, 18, 19, 20, 21, 27
 ....................................................................................................23
Over speed or low speed ....................................................................... 24, 25, 26
Low power ........................................................................................ 16, 19, 22, 23
CODE POSSIBLE CAUSE POSSIBLE SOLUTION
1 Engine On/Off switch in OFF
position.
Turn to ON position
2 Choke in wrong position Adjust choke accordingly
3 Fuel shut-off valve in closed
position
Open fuel shut-off valve
4 Unit loaded during start-up Remove load from unit
5 Faulty receptacle Contact a Customer Care Center.
6 Receptacle thermal circuit
breaker tripped
Depress and reset
7 Defective capacitor Contact a Customer Care Center.
8 Faulty power cord Repair or replace cord
9 Generator overloaded Reduce load
10 Faulty cords or equipment Check for damaged, bare or frayed
wires on equipment. Replace.