Filter
Top Products
77
MAINTENANCE AND LUBRICATION
PVT System
PVT Drying
There m ay be s ome instances when water is accidently ingested into
the PVT system. Use the following instructions to dry it out before
operating.
1. Loosen the bottom screws that secure the clutch cover.
2. Allow the water to drain.
3. Tighten the screws.
4. Apply the brakes. Start the engine.
5. Engage the park brake.
6. Shift the transmission to neutral.
7. Apply varying throttle for 10-15 seconds to expel the moisture and
air-dry the belt and clutches. Do not hold t he throttle wide open
for more than 10 seconds.
8. Allow the engine RPM to settle to idle speed. Apply the service
brakes. Release the park brake and shift the transmission to the
lowest available range.
9. Test for belt slippage. If the belt slips, repeat the process.
10. Take the vehicle to your dealer for service as soon as possible.