Filter
Top Products
CAUTION
! Do not press the h button when an SD mem-
ory cardis not fully inserted. Doing so may da-
mage the card.
! Do not press the h button before an SD mem-
ory cardhas been completely removed. Doing
so may damage the card.
1 Press the h button.
The “Monitor Setup” screen appears.
2 Touch [SD Insert].
The LCD panel opens, and the SD card slot ap-
pears.
3 Insert an SD memory card into the SD
card slot.
Insert it with the label surface facing to the up-
side and press the card until it clicks and com-
pletely locks.
4 Press the h button.
The LCD panel closes.
p If data related to map data, such as custo-
mized POI data, is stored on the SD mem-
ory card,the navigation system restarts.
Ejecting an SD memory card
(for AVIC-Z120BT)
p This section describes operations for AVIC-
Z120BT.
1 Press the h button.
The “Monitor Setup” screen appears.
2 Touch [Eject SD].
The LCD panel opens.
p Touch[Yes] if the message indicating that
the flap opens after the navigation system
restarts appears.
The navigation system restarts, and then the
LCD panel opens.
3 Press the middle of the SD memory
card gently until it clicks.
En
16
Chapter
02
Basic operation