Filter
Top Products
Using the touch panel keys
64
3
2
1
5
1 Sends a [1] key to [6] key command
The external unit can be operated by transmit-
ting the operating commands set to “1” key
through “6” key.
p Operation varies depending on the ex-
ternal unit connected. (In some cases,
some functions may not be used until
you touch and hold the key.)
2 Sends a command [a], [b], [c], or [d]
Touchto operate the external unit.
p Operation varies depending on the ex-
ternal unit connected. (In some cases,
some functions may not be used until
you touch and hold the key.)
3 Switches between automatic andmanual
function
You can turn automatic and manual function
on or off.
You can switch between “Auto” and
“Manual” functions of the external unit con-
nected.
Initially, this function is set to “Auto”.
p Operating commands set for “Auto”
and “Manual” operations vary depend-
ing on the external unit connected.
4 Uses [F1] through [F4] to operate the ex-
ternal unit
The external unit can be operated by transmit-
ting the operating commands set to “F1”
through “F4”.
p The operating commands set to “F1”
through “F4” vary depending on the ex-
ternal unit.
p Some functions may not be used until
you touch and hold the key.
5 Sends a band command
Touchto send a band command to the exter-
nal unit.
p Operation varies depending on the ex-
ternal unit connected. (In some cases,
the external unit may not respond.)
6 Recalls equalizer curves
= For details, refer to Using the equalizer
on page 172.
En
147
Chapter
30
Using the external unit (EXT1, EXT2)
Using the external unit (EXT1, EXT2)