Philips Remote Starter Remote Starter User Manual


 
EN-47
ENGLISH
Verify if the correct TV system is selected •
for your region.See Section 6.2 Manually
install channels.
If reception on only one channel is poor, •
try to fine tune this channel. See Section
6.2.1 Fine tune channels.
You receive poor picture quality from
connected devices:
Check that the devices are connected •
properly. Also, be sure to assign devices to
connectors as described in Section 7.4.1
Assign devices to connectors.
Verify that picture settings are correctly set. •
See Section 5.3.2 Adjust picture settings.
The TV did not save my settings:
Verify that the TV is set to • Home mode,
which offers you complete flexibility to
change settings. See Section 5.4 Change to
Shop or Home mode.
The picture does not fit the screen, it is
too big or too small:
Try using a different picture format as •
described in Section 5.3.4 Change picture
format.
Assign your device to connectors as •
described in Section 7.4.1 Assign devices to
connectors.
The picture position on screen is not
correct:
Picture signals from some devices do not •
fit the screen correctly. Check the signal
output of the device.
9�4 Sound issues
There is picture but no sound from the
TV:
Note D
If no audio signal is detected, the TV
automatically switches off audio output and
does not indicate malfunction.
Check that all cables are properly •
connected.
Check that the volume is not set to 0.•
Check that the sound is not muted.•
There is picture but sound quality is
poor:
Check • Sound settings as described in
Section 5.3.5 Adjust sound settings, verifying
that Stereo selected and Equalizer
settings are correct. If needed, try resetting
audio settings to standard.
There is picture but sound comes from
one speaker only:
Verify that • Balance correctly set as
described in Section 5.3.5 Adjust sound
settings.
9�5 HDMI connection issues
You encounter problems with HDMI
devices
HDCP support can delay the time taken for •
a TV to display content from a device.
If the TV does not recognise the device and •
the screen displays no picture, try switching
from one device to another and back again
to restart.
If you experience intermittent sound •
disruptions, check the user manual of the
HDMI device to verify that output settings
are correct. Alternatively, try connecting the
audio signal from the HDMI device to the
TV via AUDIO IN at the back of the TV.
If a HDMI-to-DVI adaptor or HDMI to •
DVI cable is used, check that an additional
audio cable is connected to AUDIO IN. You
must also assign the audio connector as
described in Section 7.4.2 and 7.4.3.