Filter
Top Products
SECTION ONE: Introduction
957 Installation Manual, Revision C1 Page 3
•
sunshield (P/N XP600)
•
warranty registration card (P/N GD671)
•
Northstar 957 Installation Manual (P/N GM957IM)
•
Northstar 957 Flush-Mounting Template (P/N GT957)
•
Northstar 957 Operator’s Manual (P/N GM957UG)
•
2201 WAAS/GPS antenna
•
50-foot 2201 data/power cable (P/N 957POD-CA)
•
2201 mounting screws (3 of each, P/N HS520)
•
2201 washers (3 of each, P/N HW500)
•
cable heat shrink (P/N HM1005)
•
cable heat shrink (P/N HM509)
•
6-pin cable connector for AUX port (P/N KS672)
•
optional 2701 beacon receiver, including:
-
AN205-P GPS/DGPS antenna
-
50-foot AN205-P antenna cable (P/N WC-256)
-
10-foot data/power cable (P/N 957BDM-CA)
•
optional 957 yoke-mount kit (P/N 601YOKE-IK)
•
optional remote control and batteries (P/N 957RC)
MOUNTING AND WIRING:
Step 1. Review all of the installation requirements as described in
Section Two and Section Three.
Step 2. Make sure you have all the right tools before starting the
installation.
Step 3. Install the 957—see “Mounting the 957” beginning on
page 6.
Step 4. Install the 2201 and cable— see “SECTION THREE:
Installing and wiring the 2201” beginning on page 17; or
else install the optional 2701—see “SECTION FOUR:
Installing and wiring the 2701” beginning on page 25.
NOTE:
The cables and connectors for the 957’s VIDEO
connector (input, BNC) and VGA connector
(output) aren’t supplied by Northstar, since the
required cables will depend on the particular
installation. The installer must provide these
cables.
NOTE:
If you’re installing the optional Northstar 490 echo
sounder, you’ll find the 490 and its components in
the separate 490 shipping carton.