Filter
Top Products
SECTION THREE: Installing and wiring the 2201
Page 20 957 Installation Manual, Revision C1
Using a standard antenna mast
❶
Using the 1”x 14 marine-industry standard UNS thread
mounting, install the base of the 2201 onto a standard
antenna mast. Do not overtighten or you may damage
the housing!
❷
To avoid stressing the 2201’s connector with the weight of
the cable, use a tie-wrap or similar near the 2201 to hold
the cable’s weight.
Figure 9: Mounting position for a standard mast mount
Using a flat surface
You can mount the 2201 onto a deck or any other flat surface:
❶
Using the three screws and washers provided, mount the
2201 onto the flat surface using three holes on a 1.75-inch
diameter circle (see Figure 10 below).
An optional magnetic
mount adapter (Northstar
part number AM110) is
available for certain
installations. To order, call
the Northstar Sales
Department.
3.79” (96mm)
4.50” (114mm)