North Star 25 kW Radar Detector User Manual


 
ranges, and the Range Rider will store these settings for each range. Then, when you select
a particular range again, the settings are already optimized.
Manual is a fully manual function in which you will usually need to adjust the settings
manually each time you change the range.
Gain and Sea Clutter appearance settings are available in Auto1, Auto 2 and Harbor modes.
These can be accessed by pressing the Gain or Sea Clutter buttons while in Auto1, Auto 2 or Harbor
mode with Gain or Sea Clutter set to Auto.
The default appearance setting is 25 for both Gain and Sea Clutter for all ranges.
The appearance settings can be adjusted between 0 and 50. This represents a +/- 25 step offset away
from the nominal Auto mode setting. The value set will be applied only to the current range.
14.6 Restore all the factory settings
If you need to restore ALL of the radar settings (except trigger delay, heading calibration and whether
or not a heading sensor is installed) to their factory settings, do the following:
1. From the main radar page, press
Page 1.
2. Press Restore... .
3. Press Restore factory settings to return the unit to its state when it was shipped
with the exception of the following:
trigger delay
heading calibration
whether or not a heading sensor is installed
parking calibration
This function is used before performing manual tuning (see Appendix B) or at any time it's necessary
to restore the unit to a known state.
14.6.1 Restore the factory appearance settings
Appearance settings and manual settings can be restored to values that normally produce a useful
picture as follows:
1. From the main radar page, press
Page 1.
2. Press
Restore... .
3. Press any or all of
Restore Auto, Restore Harbor, Restore Range Rider, and
Restore Manual to return to the factory appearance settings.
This completes the installation calibration. Note that the heading correction may need to be adjusted
slightly after the gain is optimized to provide a better picture.
Northstar 25 kW Radar Installation Manual
44