Filter
Top Products
The eyelets must be crimped or soldered at both locations (A) and the method of connection to the
vessel's hull is shown at (B).
If you are installing the radar processor on a vessel with a non-metallic hull, connect the radar
processor Chassis Earth to the vessel's ground network. If a vessel's ground network is not available,
leave the radar processor Chassis Earth unconnected.
12.14 Radar system checklist
When you've finished the wiring, visually check that:
each component is securely mounted and able to withstand rough sea conditions.
all the cables are correctly installed.
any cable shield mesh is correctly configured.
all cable entry points are watertight.
water can't leak into the scanner.
Now you're ready to set up the radar with the Northstar system that you're using.
13 Set up the radar with the Northstar 8000i system
Setting up the radar with the Northstar 8000i is described in the Northstar 8000i System installation
documentation for your display processor.
Northstar 25 kW Radar Installation Manual
38