Filter
Top Products
Black plate (76,1)
Model "NAV2-N" EDITED: 2007/ 3/ 9
You can also set the destination by pushing
<ENTER> in the current location map screen
and selecting [Nearby].
Setting by voice command
1. P ush <TALK> located on the st eer ing
switch.
2. After the tone sounds, speak a command.
. To display the 5 nearest Points of Interest
and select the destination from them:
“Show nearby <
POI Category
>”
. To display the nearby category list and
select the destination from it:
“Destination Nearby Places”
“Destination Nearby <
POI Category
>”
SETTING A PREVIOUS DESTINATION
This allows you to set the destination to a
location that you have previously set as the
destination and have the system calculate a
route. Up to 100 previous destinations will be
automatically stored.
If the number of previous destinations exceeds
100, the oldest one will be replaced by the new
one.
1. Push <DEST>.
2. Highlight [Previous Dest.] and push
<ENTER>. A list screen is displayed.
3. Highlight the preferred destination from the
list and push <ENTER>.
4. The selected destination is displayed at the
center of the map. Highlight [Start] after
confirming the location of the displayed
destination, and push <ENT ER>.The
system sets the destination to the selected
location and starts calculating a route.
INFO:
Even after setting a destination, you can adjust
the location of the destination, store the route,
etc.
“OPERATIONS AFTER SETTING A
DESTINATION” (page 4-24)
Setting by voice command
1. P ush <TALK> located on the st eer ing
switch.
2. After the tone sounds, speak a command.
To display the Previous Destinations list:
“Destination Previous Destinations”
4-16 Setting a destination