Filter
Top Products
Black plate (104,1)
Model "NAV2-N" EDITED: 2007/ 3/ 9
congestions.
. Use Traffic for Travel Time:
Calculates the estimated travel time to
destination taking traffic flow into considera-
tion.
. Use Traffic for Route Calculation:
Allows you to perform the route search with
the traffic information taken into considera-
tion.
When “Auto Reroute” is set, the detour
route search can be performed automati-
cally.
. Traffic Announcements:
This can provide you with the announcement
of the traffic information event on the route.
INFO:
. An XM subscription is required in order to
receive Traffic Information.
. Even when “Show Traffic Flow On Map” and
“Show Incidents on Map” are set to off, the
list display of “Info On Route” and “Nearby
Traffic Info” will not be affected.
. Even when “Traffic Announcements” is set
to off, the route guidance will not be
affected. Also, the announcement of emer-
gency information will not be turned off.
Setting by voice command
1. P ush <TALK> located on the st eer ing
switch.
2. After the tone sounds, speak a command.
To turn on/off the traffic information system:
“Traffic Info.”
RECALCULATE ROUTE
You can manually search for the route again after
changing the search con dition. When the
vehicle deviates from the suggested route, the
route from the current location to the destination
is auto matically searched again.
Re-searching the route manually
1. Push <ROUTE>.
2. Highlight [Recalculate] and push
<ENTER>.
3. A message is displayed, and the route is
recalculated.
4. Set the route conditions. After finishing the
setting, highlight [Start] and push
<ENTER>.
“PROCEDURES AFTER SETTING A
DESTINATION” (page 5-2)
Setting by voice command
1. P ush <TALK> located on the st eer ing
switch.
2. After the tone sounds, speak a command.
5-16 Route guidance