Filter
Top Products
51
4.6.2 Controlled traffic direction
The different cameras can measure the speed of one direction of the traffic, both
directions, or even several directions in an intersection, when they are mounted on a
rotating base. MioMap warns you only if you drive in a measured or possibly
measured direction.
The measured direction of the cameras are displayed with the following symbols:
4.6.3 Speed limit checked
As additional information, the speed limit checked by the camera is given for fixed,
built-in and section control cameras. When you save a camera location using the
Add Cam button in the Cursor menu (Page 26), the speed limit of the road is used by
default, but you can change the value from 30 km/h to 130 km/h with the given
control:
4.6.4 Add a new camera or edit an existing one
You can add new cameras, delete or modify the parameters of existing ones using
the Add Cam or Edit Cam buttons of the Cursor menu (Page 26). To delete an
existing camera first tap Edit Cam, then Delete.
4.6.5 Change the settings of the camera warning
You can turn on and off the camera warning, and fine-tune its settings in General
settings (Page 68 and Page 68).