Filter
Top Products
36
Getting started
Unlocking
Position 0
Before you press the KEYLESS-GO
start/stop button 1, the vehicle’s
on-board electronics have status 0 (as with
SmartKey removed).
Position 1
̈ Press KEYLESS-GO start/stop
button 1 once.
This supplies power to some electrical
consumers, such as seat adjustment.
Ignition (or position 2)
̈ Press KEYLESS-GO start/stop
button 1 twice.
All lamps (except high beam headlamp
indicator lamp and turn signal indicator
lamps unless activated) in the instru-
ment cluster come on. If a lamp in the
instrument cluster fails to come on
when the ignition is switched on, have
it checked and replaced if necessary. If
a lamp in the instrument cluster re-
mains on after starting the engine or
comes on while driving, refer to “Lamps
in instrument cluster” (
୴ page 338).
For information on starting the engine us-
ing the KEYLESS-GO start/stop button,
see “Starting with KEYLESS-GO*”
(
୴ page 47).
i
If you now press the KEYLESS-GO
start/stop button
ț once again, the ignition (position 2)
is switched on
ț twice, the power supply is again
switched off
i
If you now press the KEYLESS-GO
start/stop button once, the power sup-
ply is again switched off.
i
When you switch on the ignition, the in-
dicator and warning lamps (except high
beam headlamp indicator lamp and
turn signal indicator lamps unless acti-
vated) in the instrument cluster come
on. This indicates that the respective
systems are operational. The indicator
and warning lamps (except high beam
headlamp indicator lamp and turn sig-
nal indicator lamps unless activated)
should go out when the engine is run-
ning.