Filter
Top Products
165
Controls in detail
Control system
Setting daytime running lamp mode
(USA only)
̈ Move the selection marker with
the æ or ç button to the
LIGHT-
ING
submenu.
̈ Press button j or k repeatedly
until you see this message in the multi-
function display:
LIGHTING CIRCUIT
HEADLAMP MODE
.
The selection marker is on the current
setting.
̈ Press æ or ç to select manual
or daytime running lamp (constant)
mode. This function is not available in
countries where daytime running
lamps are mandatory.
With daytime running lamp mode selected
and the exterior lamp switch at position 0,
the following lamps will come on automat-
ically when the engine is turned on:
ț Parking lamps and low beam head-
lamps
ț License plate lamps (in low ambient
light conditions)
i
This function is not available in coun-
tries where the daytime running lamp
mode is mandatory and therefore in a
constant mode.
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
For safety reasons, resetting the
LIGHTING
submenu to factory settings
(
୴ page 161) while driving will not re-
set the daytime running lamp mode.
In the multifunction display you will
then see the message:
LIGHTING –
CANNOT BE COMPLETELY RESET TO FAC-
TORY SETTINGS WHILE DRIVING
.