Filter
Top Products
310
Operation
Tires and wheels
Reactivating the tire inflation pressure
monitor
The tire inflation pressure monitor must be
reactivated in the following situations:
ț If you have changed the tire inflation
pressure
ț If you have replaced the wheels or tires
ț If you have installed new wheels or
tires
̈ Using the tire placard on the driver’s
door B-pillar or, if available, the inside
of the fuel filler flap, make sure the tire
inflation pressure of all four tires is cor-
rect.
̈ Press button j or k repeatedly
until you see the current tire inflation
pressures for each tire appear in the
multifunction display or the following
message appears in the multifunction
display:
TIRE PRES. DISPLAY
APPEARS AFTER
DRIVING A FEW
MINUTES
̈ Press the reset button J on the in-
strument cluster (
୴ page 140).
The following message will appear in
the multifunction display:
MONITOR CURRENT
TIRE
PRESSURES?
̈ Press the æ button.
The following message will appear in
the multifunction display:
TIRE PRES. MONITOR
REACTIVATED
The tire inflation pressure monitor will
now monitor the tire inflation pressure
values of all four tires.
The following message will appear in
the multifunction display field:
TIRE PRES. DISPLAY
APPEARS AFTER
DRIVING A FEW
MINUTES
This display appears until the individual
tire inflation pressure values are
matched with the tires. The individual
values are then displayed
(
୴ page 308).
i
If you are transporting a deflated tire in
the vehicle, do not activate the tire
inflation pressure monitor until
ț the deflated tire is no longer in the
vehicle
ț you have inflated the tire to the
correct tire inflation pressure