Filter
Top Products
57
Getting started
Parking and locking
̈ Press the seat belt release button
(
୴ page 45).
Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.
̈ After exiting the vehicle, press the lock
button ‹ on the SmartKey
(
୴ page 32).
All turn signal lamps flash three times.
The locking knobs in the doors move
down.
For more information, see “Locking and
unlocking” (
୴ page 94).
Turning off the engine with
KEYLESS-GO*
̈ Place the gear selector lever in P.
̈ Press the KEYLESS-GO start/stop but-
ton to shut off the engine.
With the driver’s door closed, the start-
er switch is now in position 1. With the
driver’s door opened, the starter switch
is set to position 0, same as SmartKey
removed from starter switch
(
୴ page 34).
̈ Press the seat belt release button
(
୴ page 45).
Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.
i
With the SmartKey removed and the
driver’s door open, a warning sounds if
the vehicle’s exterior lamps are not
switched off.
Warning! G
To prevent possible personal injury, always
keep hands and fingers away from the door
openings when closing the doors. Be espe-
cially careful when small children are
around.
Before closing doors, make sure there is no
possibility of someone getting caught in a
door during closing.
i
Opening a door causes the windows on
that side of the car to open slightly.
They will return to the up position when
the door is closed.
Warning! G
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. Unsuper-
vised use of vehicle equipment may cause
an accident and/or serious personal injury.
୴୴